EF-119PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCESHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECY
Installation of firebox backing:• Install the side panels in place. Insert center panel, hold the panels in place• Install the top rod by sliding it
InstallationDECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:1. Check clearances to combustibles.2. Do not obtain combustion air from an attic, garage
InstallationDIMENSIONS - FREESTANDING:
InstallationCLEARANCES TO COMBUSTIBLES - FREESTANDING:When installing this unit on a combustible floor (for example linoleum, hardwood flo
InstallationCLEARANCES TO COMBUSTIBLES - BUILT-IN HEATER:Refer to Figures 10 and 11.Side wall to unit - 8 inches (20.3 cm)Mantel projection - 10
become hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required.3. Termination must exhaust above the in
Outside fresh air is mandatory when installing this unit in airtight homes and mobile homes. When connecting to an outside fresh air source, do not u
Figure 20: Corner Installation. InstallationMOBILE HOME INSTALLATION - FREESTANDING:2" (5 cm)2"(5 cm)6"(15 cm)Floor ProtectionFresh Air
InstallationHORIZONTAL EXHAUST THROUGH WALL INSTALLATION - FREESTANDING:Vent installation: install vent at clearances specified by the vent manufactur
Installation10. The pipe must extend at least 12” (30 cm) away from the building. If necessary, bring another length of pipe (PL type) to the outside
Table of Contents2Introduction...
InstallationINSIDE VERTICAL INSTALLATIONS - FREESTANDING:1. Choose a stove location that is ideal. See the section “DECIDING WHERE TO LOCATE YOUR PE
InstallationNon-combustiblefloor protection.Existing floor(combustible)6"(15 cm)Rain capFlashing24"(61 cm)2"(5 cm)Tee withcleanoutFresh
Installation
Non-combustiblefloor protection.Existing floor(combustible)6"(15 cm)3" (7.5 cm)PedestalWallthimbleFresh airintakeRodentmesh cap45°elbow12&qu
InstallationINSTALLATION AND REMOVAL OF THE SURROUND PANELS - FPI AND BIH:Magnetic StripsTwo (2) pieces makeup one (1) corner bracketCorner BracketsFi
REMOVAL:When maintenance is required on the unit the surround must be removed. Follow steps 3 through 6 in reverse order. The side pane
TroubleshootingDO NOT:w Switch the stove On and OFF rapidly. This may cause current spikes, which could shorten the life of the electrical components.
Troubleshooting3. The stove will not function in the “AUTO” mode when hot.w If the unit fails to operate, by-pass the auto side of the switch by inser
29Troubleshooting6. Everything else in the stove operates but the ignitor will not light the pellets.w Check the burn pot liner placement, the burn po
IntroductionPELLET QUALITY:Pellet quality is important, please read the following:Your enviro pellet stove has been designed to burn wood pellets only
8. The dial-a-fire has no effect on the fire.w Make sure all connections to the timer control module are secure.w Perform a resistance test to the dia
31Wiring Diagram120oF (49oC)IgnitorTemperatureSwitch200oF (93oC)High LimitTemperatureSensor160oF (71oC)ConvectionTemperatureSwitchPurplePurpleBlack120
Parts List32Reference NumberDescription Part Number1 120°F (49°C) Ceramic Fan Temp Sensor EC-001Freestanding Fan Controller Knob EC-040Domestic Power
33Parts ListReference NumberDescription Part NumberWindow Channel Tape 60” (1.5 m) EF-05817 FPI & BIH Ash Pan Latch EF-060Glass Set With Tape EF-0
Parts List34Reference NumberDescription Part NumberFireplace Insert Cabinet Side Right EF-132A33 Freestanding Pedestal Complete EF-138Ignitor Tube Onl
35Parts List - OptionsReference NumberDescription Part NumberLog Set 20-03648 Decorative Trivet - Painted EF-14848 Decorative Trivet - Gold EF-149Louv
Parts Diagram - Components 36
37Parts Diagram - Steel
WarrantySherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electrica
39The following information must be recorded by the installer for warranty purposes and future reference.NAME OF OWNER:_______________________________
IntroductionIMPORTANT SAFETY DATA:Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow
IntroductionASHES: Disposed ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be on a non-com
Operating InstructionsAUTOMATIC SAFETY FEATURES:Your pellet Stove has the following safety features:A. The stove will shut off when the fire g
Operating InstructionsOPERATING YOUR PELLET STOVE:Convection BlowerSpeed ControlKnob AGreen Light(Auger Light)Dial-A-FireHeat OutputKnob BAuto/ Manual
Routine Cleaning and MaintenanceNOTE: Do not use abrasive cleaners to clean the surface or any part of the stove.The following should be inspected per
ASH PAN (2-3 days)Monitor the ash level every week. Remember that different pellet fuels will have different ash contents. Ash content is a good indi
Kommentare zu diesen Handbüchern