SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER EG 28 B Vented By SHERWOOD IND
MAINTENANCE AND TECHNICAL Annually check to ensure that your Venting system is clear. Periodically check the pilot and burner. Check to see that a
Problem Possible Cause Solution Spark will not light the pilot after repeated pressing of spark igniter Defective piezo igniter Check connections
GAS LINE CONNECTION ORIFICE SIZES, PRESSURE AND BTU’S NATURAL GAS PROPANE GAS Orifice size #42 dms #53 dms Manifold pressure. 3.8” wc (0.95
The ENVIROGAS EG 28.FS.BV. will operate with no external power supply. These models have a Millivolt gas control which uses the pilot flame to genera
14PARTS AND ACCESSORIES Service Parts available from your local Envirogas Dealer Burner Control Assembly Natural Gas Pilot Assembly Propane Pilot
ADJUSTING THE VENTURI • Remove the ash shelf by undoing the screw at each end, pull shelf towards you. • Remove one screw from the cover plate loc
16 WARRANTY Because of our high standards Sherwood Industries Ltd. can offer a *Lifetime Warranty on all it’s gas products. Covered under this warr
PARTS LIST EC-001 120° F CERAMIC TEMP SENSOR EG28-108 FREESTANDING PEDESTAL EC-002 220° F CERAMIC SPILL SWITCH EG28-109 FS PEDESTAL DOOR EC-006 SI
18FS BV STOVE TOPEG28124 FS DV STOVE TOPEG28-126 FS PEDESTAL DOOREG28-109 FS PEDESTAL DOOR MAGNETEG28-056 FREESTANDING PEDESTAL EG28108FIREBOX GO
19 EG28 DOOR AND GAS TRAY ASSEMBLYEXPLODED Page 1 of 2 JULY 2001 GLASS RETAINERGLASS SET WITH TAP
SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATIONOF YOUR "ENVIROGAS" STOVE, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: GENERAL
INSTALLATION DATA SHEET The following information must be recorded by the installer for warranty purposes and future reference. Model: EG 28 B vent
TABLE OF CONTENTS Safety Precautions 2 Code Approvals 3 Deciding where to locate your stove 4 Venting 6 Installation of Log Sets and Embers 8 O
4DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: FIG. 1 Front Width: 22"/ 56cm Rear Width: 22"/ 56cm Height: 27-1/2"/ 70cm
VENT TERMINAL CLEARANCES Figure 3 A= Clearance above grade, verandah, porch, deck, or [balcony (*12 inches (30cm) minimum] B= Clear
VENTING This model must have a vent opening in the rear of the unit. Confirm this and also check that the label on the right side panel door states
A. USING AN EXISTING CHIMNEY • Measure the height of the chimney beforehand and purchase the appropriate kit. Never attempt to over stretch a flex
INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of Rock Wool embers is provided for use on the burner tray. CAUTION: Use o
OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RES
Kommentare zu diesen Handbüchern