search

Enviro M55C-FPI Bedienungshandbuch Seite 8

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 37
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
    •
  • LESEZEICHEN
    • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 7
8
Operating Instructions
opeRating youR peLLet Stove:
THE UNIT WILL NOT OPERATE WITH THE DOOR OR ASH BOX OPEN. Open the hopper lid only to re-
fuel or to adjust the controls. the unit will shut down if the hopper lid is left open for longer than
two minutes.
CAUTION: When operating during adverse weather, such as high winds or freezing rain, if the unit exhibits
dramatic changes in combustion stop using the unit immediately. Watch for blocked exhaust outlet.
CAUTION: Radiant surfaces can become very hot and can cause burns when contacted.
PRE-BURN CHECK: The burn pot liner holes must be clear and the liner installed properly against the
ignitor tube and locked in place. Check the hopper for enough pellets to start the unit.
Note: To change fuel type, ensure the Thermostat Switch is set to Manual Mode. Press the Off button and
Figure 3: Thermostat Switch
in MANUAL position.
Figure 4: Thermostat Switch
in HIGH/LOW position.
Figure 5: Thermostat Switch
in AUTO/OFF position.
then press the Fuel Type button to cycle through the available fuel types.
Note: The unit has an automatic cleaning cycle; every thirty minutes the agitator
will turn continuously for one minute to help clean out the burn pot liner.
MANUAL MODE:
All control of circuit board function is adjusted at the circuit board.
INITIAL START-UP: Press the ON / OFF button. The stove will turn on.
The Fuel Type Light will flash (the Auger Feed Rate is pre-programmed during
start-up). The Heat Level Indicator will show the Heat Level that the stove will
run at after start-up.
If this is the first time the unit has been started or the unit has run out of fuel, the auger may need to be
primed. The liner can be primed with a handful of pellets, or after the two minute prefeed, the unit can be
restarted.
The agitator will not operate for the first five minutes after the ON button has been pressed. After the ten
minutes it will pulse at the same interval as the feed auger.
When the start-up sequence is complete, the unit will switch to the designated heat setting.
Once a fire has been established, the convection blower will turn on after ten minutes.
To OPERATE: Press the Heat Level buttons to change the desired Heat Level Output setting.
The speed of the convection blower is controlled by the setting of the heat level.
The Feed Trim button pressed in conjunction with the Heat Level adjustment buttons
can be used to adjust the
feed trim
. It can be increased by two feed settings or it can be decreased by two feed settings.
HIGH/LOW MODE: (Requires a Thermostat or Timer)
INITIAL START-UP: See MANUAL MODE above.
OPERATION: When the thermostat calls for heat (contacts are closed) the stove
settings are adjustable as per Manual Mode. When the thermostat contacts
open, the HEAT LEVEL and Fans will drop down to the LOW setting until the
thermostat contacts close again. The stove will come back to the previous HEAT
LEVEL setting once the thermostat contacts close.
AUTO/OFF MODE: (Requires a Thermostat or Timer)
INITIAL START-UP: See MANUAL MODE above.
OPERATION: When the thermostat contacts close, the unit will light
automatically. Once up to temperature, the stove operates the same as in
MANUAL. When the thermostat contacts open, the stove’s HEAT LEVEL and Fans
will drop down to the LOW setting for 30 minutes. If the thermostat contacts
close within the 30 minutes, the HEAT LEVEL will return to the previous MANUAL
AUTO/OFF
HIGH/
LOW
MANUAL
Premium Pellets
Regular Pellets
Multi-Fuel
1
2
3
4
5
ON/OFF
HEAT
LEVEL
FEED
TRIM
FUEL
TYPE
COMBUSTION
AIR TRIM
AUTO/OFF
HIGH/
LOW
MANUAL
Premium Pellets
Regular Pellets
Multi-Fuel
1
2
3
4
5
ON/OFF
HEAT
LEVEL
FEED
TRIM
FUEL
TYPE
COMBUSTION
AIR TRIM
AUTO/OFF
HIGH/
LOW
MANUAL
Premium Pellets
Regular Pellets
Multi-Fuel
1
2
3
4
5
ON/OFF
HEAT
LEVEL
FEED
TRIM
FUEL
TYPE
COMBUSTION
AIR TRIM
Seitenansicht 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare
Verwandte Produkte und Handbücher für Kamine Enviro M55C-FPI
Kamine Enviro Empress Bedienungshandbuch   (35 Seiten)
Kamine Enviro C-10914 Bedienungshandbuch   (46 Seiten)
Kamine Enviro 828 DV.FS. Betriebsanleitung   (25 Seiten)
Kamine Enviro Focus Bedienungshandbuch   (26 Seiten)
Kamine Enviro Q2 Bedienungsanleitung   (1 Seiten)
Kamine Enviro C-11366 Bedienungshandbuch   (35 Seiten)
Kamine Enviro C-11089 Bedienungshandbuch   (44 Seiten)
Kamine Enviro Q1L Bedienungsanleitung   (47 Seiten)
Kamine Enviro Ascot 50-029 Bedienungshandbuch   (33 Seiten)
Kamine Enviro Q2 Bedienungsanleitung   (12 Seiten)
Kamine Enviro EF4i Bedienungshandbuch   (37 Seiten)
Kamine Enviro EF-119 Bedienungshandbuch   (19 Seiten)
Kamine Enviro Westport 50-1033 Bedienungshandbuch   (48 Seiten)
Kamine Enviro CARA DR Bedienungshandbuch   (37 Seiten)
Kamine Enviro Haven Bedienungsanleitung   (2 Seiten)
Kamine Enviro C-10450 Bedienungshandbuch   (33 Seiten)
Kamine Enviro Westport C-11290 Bedienungshandbuch   (42 Seiten)
Kamine Enviro C-11288 Bedienungshandbuch   (34 Seiten)
  • Gt-radial Just-better Thermor F-SECURE Amtrol
  • PNY Speicherkarten Gateway Auto-Kits Fortinet PoE-Adapter Bosch Power Tools Nein Radio Shack Sicherheitszugriffskontrollsysteme
  • Sangean WFR-27C Samsung LW15M13C Smeg STA4845 Toshiba H9 Samsung SAMSUNG WB650
  • Panasonic TR-930 Bedienungsanleitung Hyundai E425D Bedienungsanleitung Roland DP90S Bedienungsanleitung Sony SPK-HCA Bedienungsanleitung Defy DTD259 Bedienungsanleitung